Craftsman 315.114260 Operator's Manual page 9

RIP
GUIDE SCREW
(WING SCREW)
BEVEL CUT
ADJUSTMENT
(BEVEL ADJUSTMENT
KNOB)
BASE
ASSEMBLY
RIP GUIDE
WARNING:
Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until light on front of charger changes
from red to green.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged.
CHARGING BATTERY PACK
See Figure 2.
Charge battery pack only with the charger provided.
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
FEATURES
SPINDLE
LOCK BUTTON
LOCK-OFF
BUTTON
SWITCH
TRIGGER
UPPER
BLADE GUARD
LOWER BLADE
GUARD HANDLE
LOWER
BLADE GUARD
BLADE
BLADE WRENCH
STORAGE AREA
BLADE WRENCH
(5 mm HEX KEY)
Connect charger to power supply.
Place battery pack in charger aligning raised rib on
battery pack with groove in charger. See Figure 2.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
Normally, the red LED on charger will come on. This
indicates charger is in fast charging mode.
Red LED should remain on for approximately 1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is in
trickle charge mode. Note: Green LED will remain on
until battery pack is removed from charger or charger
is disconnected from power supply.
If both yellow and green LED come on, this indicates a
deeply discharged or defective battery pack.
Allow battery pack to remain in charger for 15 to 30
9
BATTERY
PACK
DEPTH OF
CUT ADJUSTMENT
(DEPTH ADJUSTMENT KNOB)
Fig.1