Sony BVM-X300 Operating Instructions Manual page 24

Submenu Setting




[Transfer Matrix] Select the transfer matrix from the
following:


[Input Setting Skip] Sets the skip setting when changing the
input setting by pressing the SDI 4K
button. Select [Skip]/[Not Skip] for
each input setting of [Input Setting1] to
[Input Setting4].


[SDI 2K/HD Input Setting]
24
Adjustment Using the Menus
Follow RECOMMENDATION ITU-
R BT.1702 "Guidance for the
reduction of photosensitive epileptic
seizures caused by television" or
other guidelines to use.
In the HDR display, the display
surface may emit heat when high
brightness images are output. Do not
touch the surface.
Do not display static images that
contains high brightness display,
time codes, markers, or logos for
extended periods to reduce the risk
of burn-in. Consider to apply a
displaying method with a low level
signals of 100% or less.
If a high level signal is continuously
displayed on the same area in the
HDR display, the protection
function activates wherein the
brightness of the bright part in the
display decreases to control the rise
of the surface temperature of the
OLED panel. When the level of the
bright part decreases or the change
of its position continues, the
protection function is deactivated.
However, it may take a while to
deactivate.
In that case, operating the buttons
on the front panel deactivates the
protection function immediately.
[ITU-R BT.709]
[ITU-R BT.2020]
[Skip]: Skips.
[Not Skip]: Does not skip.
Submenu Setting
[Input Setting] Sets the input setting of the SDI 2K
signal.
[Input Setting1]

[Input Setting2]

[Input Setting3]

[Input Setting4]

[Input] Set the input connector of the SDI 2K
signal.
[Input1]: Select to use SDI IN 

with Single Link.
[Input2]: Select to use SDI IN 

with Single Link.
[Input3]: Select to use SDI IN 

with Single Link.
[Input4]: Select to use SDI IN 

with Single Link.
[Input1&2]: Select to use SDI IN 

and SDI IN  with Dual Link.
[Input3&4]: Select to use SDI IN 

and SDI IN  with Dual Link.
[Interface Format] Displays the interface format of the 2K
input.
[Single-Link 3G/HD-SDI]: For

Single Link.
[Dual-Link 3G-SDI]: For Dual Link

of 3G-SDI.
[Signal Format] Select from the following when
[Interface Format] is [Single-Link 3G/
HD-SDI].
[Auto]

[422 YCbCr 10bit]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

Select from the following when
[Interface Format] is [Dual-Link 3G-
SDI].
[Auto]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]
