Main Fuel Level Sensor Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

1G-15 Fuel System:
3) Remove fuel pump assembly (1) from fuel tank (2).
Installation
CAUTION
!
When connecting joint, clean outside surface
of pipe where joint is to be inserted, push
joint into pipe till joint lock clicks and check
to ensure that pipes are connected securely,
or fuel leak may occur.
1) Clean mating surfaces of fuel pump assembly (1)
and fuel tank.
2) Put plate (2) on fuel pump assembly (1) by matching
the protrusion of fuel pump assembly (3) to plate
hole (4) as shown.
4
3) Install new gasket (2) and fuel pump assembly (1)
earth bracket (5) with plate (3) to fuel tank (4).
Tightening torque
Fuel pump assembly bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
(a)
1
2
I3RM0A170021-01
2
3
4
3
1
I4RS0A170015-01
5
3
1
2
4
I6RS0C170009-01
4) Connect fuel feed line (1) (pipe joint) to fuel pump
assembly (2).
1
5) Install fuel tank to vehicle. Refer to "Fuel Tank
Removal and Installation".
Main Fuel Level Sensor Removal and
Installation
CAUTION
!
• Do not touch resister plate (1) and deform
arm (2). It may cause main fuel level sensor
to fail.
• Be very careful not to cause damage to
fuel tube installed section (sealed section
in bore). If it be damaged, replace it with
new one, or fuel will leak from the part.
1
2
I4RS0A170014-01
S7RS0B1706018
2
I4RS0A170016-01