Electrical - Panasonic CQ-DVR592U Operating Instructions Manual

Troubleshooting
Remote Control Unit
E
Trouble
N
G
L
Battery polarities are reversed.
I
Insert the battery correctly.
S
H
Wrong the battery.
39
Check the battery.
Buttons are invalid for
operation.
The battery has run down.
Replace the battery.
Remote control unit is in the wrong direction.
Direct the remote control unit at sensor on the front panel.
Maintenance
Your product is designed and manufactured to ensure a minimum of maintenance. Use a dry, a soft cloth for
routine exterior cleaning. Never use benzine, thinner or other solvents.
Product Servicing
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest
authorized Panasonic Servicenter. The product should be serviced only by a qualified technician.
Replacing the Fuse
Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or
connecting the unit directly without a fuse, could cause fire or damage to the stereo unit.
If the replacement fuse fails, contact your nearest Panasonic Servicenter for service.
If the unit begins to operate malfunctionally
Reset switch
54
CQ-DVR592U
(continued)
Cause/Step
Reset Switch
When you press this switch with a tough pointed object, the user
setting is restored after irregular recovery. And, all your settings will be
canceled.
Caution:
Press this switch when any operation buttons do not work. If
≥
the unit does not become restored even after pressing the
switch, contact your nearest Panasonic Servicenter for
service.
Anti-Theft System
This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable.
The security indicator will blink.
Place the Removable Face
Plate into Case
1 Switch off the power of the unit.
2 Remove the removable face plate. ( page 67)
3 Gently press the button of the case and open the
cover. Place the face plate into the case and take
it with you when you leave the car.
Install Removable Face Plate
1 Fit the face plate with its left hole on one of the
pins provided on the main unit.
2 Fit the other hold on the other pin applying slight
pressure.
3 Move the face plate up and down a few times to
make sure it is secure. Then close the front
panel and press down the right side of the face
plate until it clicks into plate.
Security Indicator
The security indicator blinks when the removable
face plate is removed from the unit.
Active the security function in the function settings.
( page 46)
Panel Removal Alarm
This alarm sounds to warn you not to forget to
remove the panel before leaving your car. This
function is activated when the security indicator is on.
Caution:
≥ This face plate is not waterproof. Do not expose it to water or excessive moisture.
≥ Do not remove the face plate while driving your car.
≥ Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level.
≥ Do not touch the contacts on the face plate or the main unit, since this may result in poor electrical
contacts.
≥ If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.
≥ To avoid damaging the front panel, do not push it down or place objects on it while it is open.
Removable face
plate case
Contact
2
3
1
Security indicator
CQ-DVR592U
E
N
G
L
I
S
H
40
55