Selecting A Speaker - Yamaha YVC-1000 User Manual

Selecting a speaker

Select whether to output incoming sound through only the built-in speaker, only external speakers, or both the built-in
speaker and external speakers.
1
Hold down the volume + and - buttons (
same time.
The volume + and - buttons (
The selected speaker is shown on the level indicator, and the voice guidance prompts you to determine the
speaker.
Indicator pattern (
2
Press the volume + (
speaker.
If the speaker is changed, the voice guidance notifies the user of information about the new speaker.
If the volume + (
the normal mode.
Operation
Press the volume + button (
Press the volume - button (
y
Both the built-in speaker and external speakers cannot be disabled.
Volume + and - buttons
The table below shows indicator patterns viewed from this side.
) flash green.
: ON, : OFF)
Sound is output only from the built-in speakers.
Sound is output from both the built-in speakers and external speakers.
Sound is output only from external speakers.
) button or volume - (
) button or volume - (
). Switches whether to enable or disable the output of external speakers.
). Switches whether to enable or disable the output of the built-in speaker.
Level indicator
) for 2 seconds or more at the
) button to change the required
) button is not pressed for 6 seconds or more, the product returns to
Changed contents
Speaker output
30