Adjusting The Label Length - Brother P-Touch PT-D450 User Manual

Setting
• Select this setting when
using special tape.
• When using Fabric Iron-On
Tapes or Heat Shrink Tube,
set [Special tape] for [Cut
Option] before printing.
After printing, remove the
tape cassette from the
Special
P-touch labeler and use
tape
scissors to cut the tape.
NOTE
• When the cut option is set to [No Cut] or [Chain], it stops in the middle
of printing area after the last label is printed. After [OK to Feed?] is
displayed, press (
to the text entry screen.
• When the cut option is set to [Large Margin], [Small Margin], [Chain],
after printing the message [Cut tape or press Enter to continue.] is
displayed and the P-touch labeler goes into the cut pause mode. By
pressing the Tape cutter lever, you can cut the tape at the position
you set in [Cut Option].

Adjusting the Label Length

When the tape cassette comes to the end, the printed length may be less
accurate.
In this case, you can adjust the label length.
( ) / [Settings]
( ) /
or ( ).
NOTE
Approximately 1 % of the total label length will be adjusted by 1 level.
Description
) or (
( ) or (
[Label Length]
• When multiple copies are printed one
time:
(23.9 mm)
• When a label is printed two times:
ABC
0.94"
(23.9 mm)
1. 1st print
2. 2nd print
) to feed the tape. Press (
) / [Adjustment]
( ) or ( )
LABEL PRINTING
Example
ABC ABC
0.94" 0.16"
(4 mm)
1
ABC
1.1"
(27.9 mm)
) to return
(
/ [-5 - +5]
Adjusting the Label Length
0.16"
(4 mm)
2
) or
( )
36