Connecting The Handset And Charger - Motorola S1201 Startac User Manual

Installing and charging the handset
1. Remove the battery cover from the back of the handset
and insert the rechargeable Ni-MH battery cells
supplied. Please note the '+' and '-' markings inside the
battery compartment and insert in the correct direction.
2. Clip the battery cover back into place.
3. If you are charging the batteries for the first time, place
the handset on the base to charge for at least 24 hours
continuously.
4. When the handset is fully charged,
appear steady on the display. Plug the other end of the
telephone line cord (make sure that one end is already
plugged into the base) into the telephone wall socket.

Connecting the handset and charger

(for multi-pack only)
If you have purchased a multiple pack, you will need to carry
out this process for all the handsets and chargers.
1. Plug the power adaptor into the socket marked
the underside of the charger and plug the other end into
the mains power wall socket.
Getting started
icon will
2. Remove the battery cover from the back of the handset
and insert the 2 x AAA NiMH rechargeable batteries
supplied. Please note the '+' and '-' markings inside the
battery compartment and insert in the correct direction.
3. Clip the battery cover back into place.
4. If you are charging the batteries for the first time, place
the handset on the charger to charge for at least 24
hours continuously.
5. When the handset is fully charged,
on
appear steady on the display.
The display will show the time and handset number
(e.g. 2) to indicate that it is registered to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery
cells (2 x AAA Ni-MH 450mA rechargeable batteries)
supplied with your S12.
icon will
7