Pioneer AVIC-F60DAB Operation Manual page 188

Appendix
Appendix
Message
Already stored.
Memory full. Connect iPod.
Memory full. Tags not stored.
Connect iPod.
iPod full. Tags not transferred. Memory used for tag information on
Tag transfer failed. Reconnect
your iPod.
Bluetooth
Message
Error-10
MirrorLink
Message
The application list could not
be read out.
There is no supported applica-
tion on your MirrorLink de-
vice.
188
Engb
Cause
This tag information is already
stored in memory.
The tag information is successfully
stored. The flash memory of this
product has become full.
This product's flash memory used
as the temporary storage area is
full.
the iPod is full.
This product's tag information can-
not transfer to the iPod.
Cause
The power failed for the Bluetooth
module of this product.
Cause
Failed to load the application list.
No supported applications can be
found.
Action
Tag information can only be saved once for
any given song. Tag information cannot be
saved for the same song more than once.
The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
Sync the iPod with iTunes and clean up the
tagged playlist.
Check the iPod and try again.
Action
Turn the ignition switch to OFF and then to
ON.
If the error message is still displayed after per-
forming the above action, please contact your
dealer or an authorised Pioneer Service Sta-
tion.
Action
! Disconnect the cable from the smartphone,
and then connect the smartphone again after
a few seconds.
! Turn the ignition switch to OFF and then to
ON.
If the error message is still displayed after per-
forming the above action, reset the smart-
phone.
If the error message is still displayed after per-
forming the above action, please contact your
dealer or an authorised Pioneer Service Sta-
tion.
Install MirrorLink compliant applications to
your MirrorLink device.