Charging Your Sonicare; Safety Information; Technical Information; Repair Instruction - Philips HX6711 Service Manual

CHARGING YOUR SONICARE

Charging Your Sonicare
Note: It takes at least 24 hours to fully charge the battery.
Plug the charger into a live electrical outlet and place the handle
on the charger. The battery indicator light located in the power
on/off button flashes to indicate that the toothbrush is charging.
When the Sonicare is fully charge, the battery charge indicator
light will stop flashing
Battery charger indicator
Indicates amount of charge left in battery.
Deluxe charge indicator
Solid green LED: 50-100%
Flashing green LED: 10-49%
Flashing yellow LED: less than 10%
Standard charger indicator
Solid green LED: 50-100%
Flashing green LED: less than 50%
If the battery charge of your Sonicare is low, you will hear 3
beeps at the end of the brushing cycle and the charge indicator
LED flashes yellow for 30 seconds.
When the handle is placed in the charger, the charge indicator
LEDs will display the above patterns indicating the level of
charge.

SAFETY INFORMATION

- Consult your physician prior to using Sonicare if you have
medical concerns.
- Sonicare has been tested and is compliant with safety standards
for electromagnetic devices.
- Do not place or store the charger where it can fall or be pulled
into a bathtub, sink or toilet.
- DO NOT plug the charger into an outlet with incorrect voltage.
This product is designed to operate within a range of 100 to 240
volts. Voltage converters and plug adapters DO NOT guarantee
voltage compatibility. Never force the plug into an outlet.
- This appliance

TECHNICAL INFORMATION

Toothbrush Handle
- Voltage : 4.05 Volts d.c. at full charge
- Power consumption : 2 watts
- Charging time : Empty-to-full: 24 hours
- Operating time : Full-to-empty: 40 minutes
- Battery type : Lithium Ion
Travel Charger
- Voltage / Frequency : 100-240V, 50 - 60 Hz
- Power consumption :
0.4 watts @ 100V / 1.4 watts @ 240V

REPAIR INSTRUCTION

- Brush head
In case of a defective brush head, the complete brush head must
be replaced.
- Charging unit
4235-057-54621 _ 11_01_30
(YY_MM_DD)
HX6711, HX6730, HX6731, HX6732,
HX6733, HX6780, HX6781, HX6782
In case of a defective charging unit or cordset, the complete
charging unit must be replaced.
- Handle toothbrush
The batteries inside cannot be replaced. In case of a defect, the
complete unit must be replaced.
- Charging the handle
The handle should be charged for at least 24 hours during the
first few days of use.
Environment
- The rechargeable battery inside your Sonicare cannot be replaced,
but is easy to remove for recycling or proper disposal.
- If you have any recycling questions, contact your local waster
management office.
Removing the rechargeable battery
1. To deplete the rechargeable battery of any charge,
remove the handle from the charger, turn on the Sonicare
and let it run until it stops. Repeat this step until you can
no longer switch on the Sonicare.
5. The rechargeable battery can now be recycled and the rest
of the product discarded appropriately.
2. Insert a screwdriver into the
slot located at the bottom of
the handle and turn
counterclockwise to release
the bottom cap.
Hold the handle upside down
3.
and push down on the shaft
to release the internal
components of the handle.
Insert the screwdriver under
4.
the circuit board, next to the
battery connections, and
twist to break the
connections. Remove the
circuit board and pry the
battery from the plastic
carrier.
2-6