Bosch Carephone 50 ISA-50-MS User And Programming Manua page 30

30 en | Programming
20 Dialling modes
Ascertain whether the telephone line operates with the pulse
dialling mode (PD) or with tone dial. You can identify tone dial by
the fact that when you dial you hear tones of different pitch in
the telephone receiver. Selecting pulse dialling will only be
necessary in exceptional cases.
You program:
23 Waiting time for repeated emergency call
This function is used to check whether a person rendering
assistance arrives promptly. An emergency call is repeated until
it is acknowledged by pressing the S button on the HTS50.
The emergency call is repeated if this time is exceeded.
24 Confirmation with call
When the repeated emergency call has been acknowledged, you
can speak directly to the call centre.
You program:
25 Radio link monitoring
The HTS50 can monitor the RF transmitters that are assigned to
it. The RF transmitters send a signal to the HTS50 at regular
intervals (every 31 hours). A fault message is sent to the centre if
the HTS50 does not receive this signal at least once a week.
You program:
ISA-50-MS V2 I 2008.02
0 = PD
1 = Tone dial
Enter a time between 0 and 99 minutes.
0 = Off.
0 = the repeated emergency call is acknowledged by
pressing the S button; a call is not made to the call centre.
1 = the repeated emergency call is acknowledged by
pressing the S button; a call is made to the call centre. The
person rendering assistance can speak to the call centre
immediately.
0 = radio link monitoring off
1 = radio link monitoring on
User Manual
Carephone 50
Bosch Security Systems