Important Safety Instructions; Pre-Installation Requirements - Kenmore 41791122310 Installation Instructions Manual

important Safety instructions
For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent
property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
A WARNING- RiSK OF FiRE
Read all of the following instructions before installing and using this appliance:
° Destroy the carton and plastic bags after the dryer is unpacked. Children might use them for play. Cartons covered
with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Place all materials in a
garbage container or make materials inaccessible to children.
° Clothes dryer installation and service must be performed by a qualified installer, service agency or the gas supplier.
° Install the clothes dryer according to the manufacturer's instructions and local codes.
° The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the Nation-
ai Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian electrical code C22.1 part 1.
° The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel
Gas Code ANSI Z223.1, or in Canada, CAN/ACG B149.1-2000.
° The dryer is designed under ANSI Z 21.5.1 or ANSI/UL 2158 - CAN/CSA C22.2 No. 112 (latest editions) for HOME
USE only. This dryer is not recommended for commercial applications such as restaurants, beauty salons, etc.
° Do not install a clothes dryer with flexible plastic or flexible foil venting material. Flexible venting materials are
known to collapse, be easily crushed and trap lint. These conditions wiii obstruct clothes dryer airflow and increase
the risk of fire.
° Do not stack a dryer on top of washer already installed on pedestal. Do not stack dryer on top of another dryer. Do
not stack washer on top of dryer. Do not stack washer on top of another washer.
° The instructions in this manual and aii other literature included with this dryer are not meant to cover every possible
condition and situation that may occur. Good safe practice and caution MUST be applied when installing, operating
and maintaining any appliance.
WHAT TO DO IF YOU SMELL GAS:
° Do not try to light any appliance.
° Do not touch any electrical switch; do not use any
phone in your building.
° Clear the room, building or area of aii occupants.
° Immediately caii your gas supplier from a neighbor's
phone. Follow the gas suppiier's instructions.
° If you cannot reach your gas supplier, caii the fire
department.
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one
person move or lift the appliance.
Save these instructions
for future reference.
Pre-lnstallation Requirements
Tools and materials needed for installation:
or
Adjustable Phillips, straight, & Adjustable Universal wrench Pipe wrench LP-resistant
pliers square bit screwdrivers wrench supplied with for gas thread tape
matching washer supply (for natural gas
or LP supply)
3-wire or 4-wire 4in. gas line
240 volt cord kit (10.2 cm) shutoff valve
(electric dryer) clamp (gas dryer)
4 inch, rigid metal or
semi-rigid metal exhaust duct work
Carpenter's level
1/2"NPT union flare
adapters (x2) and
flexible gas supply line
(gas dryer)
or
External
vent hood
Metal foil tape
(not duct tape)