Makita GV7000C Instruction Manual page 5

cause loss of control leading to personal
injury.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Make sure the abrasive disc is not con-
tacting the workpiece before the switch is
turned on.
9. When sanding metal surfaces, watch out
for flying sparks. Hold the tool so that
sparks fly away from you and other per-
sons or flammable materials.
10. Do not leave the tool running. Operate the
tool only when hand-held.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V ....................... volts
A ....................... amperes
Hz ..................... hertz
................ alternating current
11. Do not touch the workpiece immediately
after operation; it may be extremely hot
and could burn your skin.
12. Check that the workpiece is properly sup-
ported.
13. Pay attention that the wheel continues to
rotate after the tool is switched off.
14. This tool has not been waterproofed, so
do not use water on the workpiece sur-
face.
15. Ventilate your work area adequately when
you perform sanding operations.
16. Use of this tool to sand some products,
paints and wood could expose user to
dust containing hazardous substances.
Use appropriate respiratory protection.
n
....................no load speed
˚
....................Class II Construction
.../min................revolutions or reciprocation per
minute
USD201-2
5