Installation Requirements - Whirlpool UXT4230ADW0 Installation Instructions And Use & Care Manual

INSTALLATION
Gather the required tools and parts before starting installation
Read and follow the instructions provided with any tools listed
here.
Tools needed
Drillwith %" _
(3 mm), 1/2" _/
(13 ram) _f' _" .._
(3cm) bits _ d y _"
Caulking gun and weatherproof _
caulking compound _ A
Jgsaw orkeyhoe saw
Parts supplied
Remove parts from package. Check that all parts are included.
I
Parts needed
UL L StedicsA _ _1 UL LiSted/csA _,.t_-_ I !20v, 75V (r-_.) I
Appr0ved _ Approved W' (13 mm) max mum,
I
wire connectors stra,n re,,e f !ype E26 .qP I
! I mcanaescen[ ramp !
t®TORX and T10 are registered trademarks of Acument Intellectual Properties, LLC.
REQUIREMENTS
For 7" (17.8 cm) round vented installations
7,(17.8cm) _ 7" (17.8 cm )
r°und / /J_ round damper
metalvent (_. /_ Partaumbe r ......
sYstem with __.V" W10355451"
wall or roof cap i
Vent Clamps aS 7, (17:8
req u red round vent _ _._
mounting plate _..__ ._
Part Number __-" _
W10388168*
For 3V4" x 10" (8.3 x 25.4 cm) rectangular vented installations
31/4"o"
(8.3 x 25,4 cm) rectangular
metal vent sYSte m with [
wall or roof cap
Optional accessories
Charcoal
*For information on ordering, see the "Assistance or Service"
section.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
• It is the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located inside the range hood on
the left wall.
• Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
• Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range manufacturer installation instructions before
making any cutouts.
• This range hood is recommended for use with cooktops with
a maximum total rating of 40,000 Btus or less.
• Grounded electrical outlet is required. See "Electrical
Requirements" section.
• All openings in ceiling and wall where range hood will be
installed must be sealed.
These range hoods are factory set for vented installations.
Models that are capable of being installed as non-vented
(recirculating) require charcoal filters. See the "Assistance or
Service" section for information on ordering charcoal filters.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local
codes.