Makita HM1303B Instruction Manual page 9

1
2
1. Screwdriver
2. Brush holder cap
1. Screwdriver
2. Plate 50
1
1. Hammer grease
Use a screwdriver to remove the brush holder caps. Take out
002956
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
Lubrication
002970
This tool requires no hourly or daily lubrication because it
1
has a grease-packed lubrication system. It should be relubri-
cated after every 6 months of operation. Send the complete
tool to Makita Authorized or Factory Service Center for this
lubrication service. However, if circumstances require that
2
you should lubricate it by yourself, proceed as follows.
First, switch off and unplug the tool.
Remove the plate 50 using a screwdriver, then replenish with
002971
fresh grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the speci-
fied amount of grease (approx. 30 g; 1 oz) can cause faulty
hammering action or tool failure. Fill only with the specified
amount of grease.
Reinstall the plate 50 and secure with the screws.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
9