General; Cleaning; Removing Of The Machine Hoods - Husqvarna Rider 213 C Owner's Manual

General

Service
Low season is the most suitable time to perform a service or
overhaul of the machine in order to ensure high function
safety during high season.
When ordering spare parts state your machine's purchase
year, model, type, and serial number.
Always use genuine parts.
An annual check-up by an authorised servicing dealer is a
good way to ensure that your ride-on mower performs at its
best the following season. Ensure that all service steps are
documented.

Cleaning

Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
IMPORTANT! Always park the machine on a level surface
with the engine OFF before performing any maintenance.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure.
Do not direct the jet towards electrical components or
bearings.
Do not rinse hot surfaces such as the engine and exhaust
system.
Put the cutting unit in the service position first. Hose down the
cutting unit with water underneath each time it is used, avoid
using a high pressure washer.
It is recommended that you start the engine and run the
mower for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
IMPORTANT! Avoid using a high pressure washer or a
steam cleaner.
There is a major risk of water penetrating into bearings and
electrical connections. Corrosion attack can result, which
will lead to running problems. Cleaning additives generally
aggravate the damage.
22 –
English
MAINTENANCE AND SERVICE

Removing of the machine hoods

Engine cover
The engine becomes accessible for service when the engine
cover is opened.
Fold the seat forward, loosen the snap lock under the seat
and fold the cover backwards.
Front cover
Release the clip on the front hood and lift off the fender.
Right-hand fender
Remove the accelerator knob (1), screws (2), and remove the
cover.
2
1
2
2
Left-hand fender
Loosen the screws holding the wing cover and lift off the
cover.