Sa1232Z Specifications - Mackie SA1232Z User Manual

SA1232z SPECIFICATIONS

Acoustic Performance
Frequency Range (–10 dB)
Frequency Response (–3 dB)
Horizonal Coverage Angle (–6 dB)
Vertical Coverage Angle (–6 dB)
Directivity Factor; DI (Q)
Max SPL long-term
Max SPL peak
Crossover Points
Input/Output
Input Type
Input Impedance
Loop-Through
Level Control
High-Frequency Section
Voice Coil Diameter
Horn Exit Diameter 1.0 in/25 mm
Phase Plug
Diaphragm Material Titanium
Magnet Material
Mid-Frequency Section
Diameter
Phase Plug
Diaphragm Material Epoxy-reinforced cellulose
Magnet Material
Low-Frequency Section
Number of Drivers
Woofer Diameter
Voice Coil Diameter
Diaphragm Material Epoxy-reinforced cellulose
Magnet Material
Power Amplifiers
Low-Frequency Power Amplifier
Rated Power
Rated THD
Design
Mid and High-Frequency Power Amplifiers
Rated Power
Rated THD
Design
Line Input Power
US
Recommended Amperage Service:
Europe
Recommended Amperage Service:
AC Connector
39 Hz–20 kHz
50 Hz–18 kHz
90º averaged 2 kHz to 10 kHz
40º averaged 2 kHz to 10 kHz
11.2 (13.2) averaged 2k Hz to 10 kHz
133 dB @ 1m
136 dB @ 1m
700 Hz, 3000 Hz
Female XLR Balanced/Unbalanced
50 kohms balanced
Male XLR Balanced/Unbalanced
(parallel with input)
Rotating knob (–15 to +5 dB),
center detent at 0 dB
1.75 in/44 mm
3-slot optimized geometry
Neodymium
6.0 in/152 mm
Optimized geometry
Neodymium
2
12.0 in/305 mm
3.0 in/75 mm
Ferrite
1100 watts rms
< 0.03%
Class G, Hybrid
100 watts rms
< 0.03%
Class AB
120V, 60Hz
20 amps
230V, 50Hz
16 amps
3-pin IEC 250 VAC
Safety Features
Input Protection
Display LEDs
Construction Features
Basic Design
Material
Finish
Handles
Grille
Physical Properties
Height
Front Width
Rear Width
Depth
Weight
Mounting Methods
The SA1232z should never be pole-mounted.
The cabinet has no rigging points and is not
suitable for flying. Never attempt to suspend the
cabinet by its handles.
Disclaimer
Since we are always striving to make our products better by in-
corporating new and improved materials, components, and manufac-
turing methods, we reserve the right to change these specifications
at any time without notice.
"Mackie" and the "Running Man" figure are registered trademarks
of LOUD Technologies Inc.
All other brand names mentioned are trademarks or registered
trademarks of their respective holders, and are hereby acknowledged.
©2004 LOUD Technologies Inc.
All Rights Reserved.
Low frequency dynamic bass
protection, rms limiting, power
supply and amplifier thermal
protection
Power ON, Signal Present, Limit,
Thermal (cool down auto-reset)
Trapezoidal, 10º sides
13-ply Baltic birch, resin end caps
Wear-resistant textured black
PVC vinyl
One on each side, one top, one bottom
Perforated metal with weather-
resistant coating
50.0 in/127.0 cm
19.1 in/48.5 cm
13.9 in/35.3 cm
18.1 in/46.0 cm
132 lb/60 kg
Floor mount only.
9