Setting Network Driver Details; Driver Installation For The Ati Rage Xl Display Adapter - NEC EXPRESS5800/120Re-2 Service Manual

Setting Network Driver Details.

1. Open the Control Panel and double-click the "Intel(R) PROSetII" icon. The
82546EB Based Dual Port Network Connection screen displays.
2. Select "Intel(R) 82546EB Based Dual Port Network Connection #1."
3. Select the "Link Configuration" tab and set the "Auto Negotiation" value to
DISABLE. Also set the "Forced Speed and Duplex" value according to the
value specified for your HUB.
4. Select "Intel(R) 82546EB Based Dual Port Network Connection #2."
5. Select the "Link Configuration" tab and set the "Auto Negotiation" value to
DISABLE. Also set the "Forced Speed and Duplex" value according to the
value specified for your HUB.
Driver Installation for the ATI RAGE XL
Display Adapter
To take full advantage of the on-board ATI RAGE XL display adapter, perform
the following driver installation procedure:
1. Power on, start Windows 2000, and log on.
2. Insert the EXPRESSBUILDER CD into the system CDROM drive. The
"Start" Menu displays. Cancel out of the Start menu and run:

D:\WINNT\Video\W2k\Setup.exe
(where D: is the drive letter for your CDROM drive.)
3. Follow the screen prompts.
4. When the message "Digital signature not found" displays, select YES to
continue the installation.
5. At the conclusion of the ATI Rage XL installation, reboot the system.
Note:
When selecting the "1000/Full" setting, set
"Auto Negotiation" to ENABLE and select only the
"1000/Full" setting at the "Negotiable Speeds and
Duplexes" item. Also, add/delete any other protocols and
services, as necessary.
Installing and Configuring Windows 2000 B-7