Setting Mode - AEG FAVORIT 88009 W0P/AU User Manual

12 www.aeg.com
7.1 Using the detergent
A
7.2 Setting and starting a
program

Setting mode

For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when all the program indicators
come on and the display shows 2 hori-
zontal status bars.
If the control panel does not show this
condition, press and hold at the same
time Delay and Start until the appliance
is in setting mode.
Starting a program without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Press Program again and again until
the indicator of the program you
want to set comes on. You can also
set the applicable options.
• The duration of the program flash-
es in the display.
• The indicators of the phases that
are foreseen for the program come
on.
5. Press Start to start the program.
• When the program starts, only the
indicator of the running phase
stays on.
B
30 A
20
+ -
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the program has a prewash phase,
put a small quantity of detergent on
the inner part of the appliance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
• The program duration starts to de-
crease with steps of 1 minute.
Starting a program with delay
start
1. Set the program.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The Delay indicator comes on.
• The delay time flashes in the dis-
play.
• The indicators of the phases that
are foreseen for the program go
off.
3. Press Start to start the countdown.
• The countdown starts to decrease
with steps of 1 hour.
When the countdown is completed, the
program starts. The indicator of the run-
ning phase comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
program is cancelled.
1. Press and hold, at the same time, De-
lay and Start until all the program in-