7-1/4” (184MM), 15 AMP CIRCULAR SAW INSTRUCTION MANUAL CATALOG NUMBER CS1015 Thank you for choosing Black & Decker! To register your new product go to www.BlackandDecker.com/NewOwner PLEASE READ BEFORE RETURNING THIS PRODUCT FOR ANY REASON. If you have a question or experience a problem with your Black & Decker purchase, go to http://www.blackanddecker.com/instantanswers...
SAFETY GUIDELINES - DEFINITIONS It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used to help you recognize this information. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
5) SERVICE e) Do not overreach. Keep proper footing and balance at all times. a) Have your power tool serviced by a quali ed repair person using only This enables better control of the power tool in unexpected situations. identical replacement parts. This will f) Dress properly.
freely and does not touch the blade or any other part, in all angles and depths of cut. blade can dig into the top surface of the b) Check the operation of the lower wood causing the blade to climb out of the guard spring.
Page 5
ALWAYS wear certi ed safety equipment: full speed before starting a cut. Always keep handles dry, clean and free Z94.3). of oil and grease. Hold the tool rmly with both hands when in use. Always be alert at all times, especially during repetitive, monotonous operations.
TO REDUCE THE RISK OF KICKBACK ripping. Be careful as the cut off strip can sag or twist, closing the cut and pinching the times. pressure treated and freshly cut green causing a pinched blade. lumber can heavily load the saw which can Fig. 1).
Page 7
OVERVIEW (FIG. 5) 2. Main handle 6. Saw blade lower guard 8. Saw blade spanner wrench 10. Outer blade clamp washer 11. Blade retaining bolt Tip of tooth Surface of wood the saw shoe. position. The corresponding bevel saw shoe in place. ASSEMBLY / ADJUSTMENT SET-P WARNING: Always unplug saw from ATTACHING THE BLADE (FIG.
the spanner wrench into the holes of the outer washer. Securely tighten the blade retaining Safety Rules). screw by holding the spanner wrench tighten the blade retaining screw. WARNING: It is important to support firmly to prevent loss of control which could cause personal injury.
blade guard to an upward position. MAINTENANCE Lower rear of foot plate until blade Use only mild soap and damp cloth to teeth almost touch cutting line. clean the tool. Never let any liquid get the tool into a liquid. to open freely as you start the cut).
for repair or replacement at our option. the phone directory. This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary from state to state or province to province. Should you have any questions, contact the intended for commercial use.