Turn Signal Lamp Switch - Mitsubishi 2010 Fuso FE Owner's Manual

OFF
position
position
position
*: Illuminated by daytime running light system
NOTE:
Even when the vehicle is operated with the lighting
switch in the "OFF" or
running light system causes the low-beam head-
lamps to be lit. (The headlamps are dimmer than
when activated using the lighting switch.) The
indicator lamp is also lit. When the parking brake is
applied or the engine is stopped, the headlamps
and the
3 Passing signal/dimmer switch
Passing signal
Pulling the lever up activates the high beams until
the lever is released. Use this to flash a signal when
overtaking another vehicle.
Dimmer
With the headlamps illuminated, pushing the lever
down activates the headlamp high beams and pull-
ing it back to the original position reactivates the low
Z11860
beams. When the high beams are on, indicator
lamp

4 Turn signal lamp switch

Turn signal
Moving the lever forward or backward activates the
corresponding turn signal causing it to flash. At the
same time, the corresponding indicator lamp
flashes.
When the steering wheel is returned to the neutral
position after a right or left turn, the switch automat-
ically moves back to the neutral position and the
lamp stops flashing. After making a moderate turn,
Z11861
however, the switch will sometimes not return auto-
matically. In this case, put the switch in the neutral
position by hand.
Identification, clearance
and side marker,
parking, tail, license, and
meter illumination lamps
Off
On
On
indicator lamp go off.
lights up.
5-19
Headlamps
On*
On*
On
position, the daytime
or