Cancel - Motorola LS3578 Product Reference Manual

2 - 2 LS3578 Product Reference Guide
Standard Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Short high-low beeps
Long low-long high beeps
Long low-long high-long low-long high
beeps
Four long low beeps
Five high beeps
Parameter Menu Scanning
Short high beep
Long low-long high beeps
Short high-short low beeps
Short high-short low-short high-short low
beeps
Long low-long high-long low-long high
beeps
ADF Programming Normal Data Entry
High-low beeps
Low-low beeps
High-high beeps
High-low-high-low beeps
High-low-low beeps
Scanner has unpaired with the cradle.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after scanning a
bar code, check the host device to determine if it received the
transmitted data. The scanner may have transmitted the last bar
code scanned after losing the connection.
Unsuccessful pairing attempt. See Auto-reconnect Feature on
page 4-15.
Remote device rejected connection attempt, possibly due to an
attempt to pair with a cradle that is already paired with the
maximum number of scanners.
1. A transmission error was detected in a scanned symbol. The
data is ignored. This occurs if a unit is not properly configured.
Check option setting.
2. When communicating with a cradle, the cradle acknowledges
receipt of data. If the acknowledgment is not received, this
transmission error beep sequence sounds. Data may still have
been received by the host. Check the host system for receipt of
transmitted data. If data was not received by the host, re-scan the
bar code.
Emitted every 5 seconds while a reconnection attempt is in
progress. See Auto-reconnect Feature on page 4-15.
Correct entry scanned or correct menu sequence performed.
Input error; incorrect bar code, programming sequence, or Cancel
scanned. Scanner remains in program mode.
Keyboard parameter selected. Enter value using numeric bar
codes.
Successful program exit with change in the parameter setting.
Out of host parameter storage space. See Default Parameters on
page 5-4.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message
bar code.
Enter another criterion or action, or scan the Save Rule bar code.
Rule saved. Rule entry mode exited.
All criteria or actions cleared for current rule, continue entering
rule.
Indication