The Advanced Settings Tab; Figure 7-4: Utility's Advanced Settings Screen - Linksys WGA54G User Manual

Wireless-G Game Adapter

The Advanced Settings Tab

Use the Advanced Settings screen to change the Game Adapter's advanced wireless settings, clone a MAC
address onto the Game Adapter, change the password, or restore its default settings.
LAN
IP Address - Select Obtain IP address automatically (DHCP) if your network router automatically assigns IP
addresses. Select Use the following IP settings if you want to assign a static or fixed IP address to the Game
Adapter. Then enter the IP Address, Subnet Mask, and Gateway address in the fields provided.
IP Address - This IP Address must be unique to your network.
Subnet Mask - The Game Adapter's Subnet Mask must be the same as your wired network's Subnet Mask.
Gateway - Enter the IP address of your network's Gateway here.
Advanced Wireless
Transmission Rate - The rate of data transmission should be set depending on the speed of your wireless
network. You can select from a range of transmission speeds, or keep the default setting, Automatic, to have the
Game Adapter automatically use the fastest possible data rate and enable the Auto-Fallback feature. Auto-
Fallback will negotiate the best possible connection speed between the Game Adapter and your wireless router
or access point.
Mode - If you have both Wireless-G and Wireless-B devices in your network, keep the default setting, Mixed
Mode. If you have only Wireless-G devices in your network, select G-Only Mode for maximum network speeds.
Authentication - The default is set to Auto, which allows either Open System or Shared Key authentication to be
used. For Open System authentication, the sender and recipient do NOT use a WEP key for authentication. For
Shared Key authentication, the sender and recipient use a WEP key for authentication. Select the authentication
method your network is using, Open System or Shared Key. If you are not sure which method to select, keep the
default, Auto.
Cloning
Cloning Mode - The MAC cloning feature allows you to clone the MAC address of the device currently connected
to the Game Adapter's Network port. The Game Adapter will actively scan for a new MAC address to be cloned
whenever you disconnect and re-connect the Game Adapter through its Network port. The default setting,
Automatic, enables the MAC cloning feature. To disable MAC address cloning, select Disabled.
Chapter 7: Using the Wireless-G Game Adapter Web Configuration Utility
The Advanced Settings Tab

Figure 7-4: Utility's Advanced Settings Screen

32