Linksys Owtalk Configuration Manual page 2

Overview
This guide shows how to configure Linksys PAP2 Analog Telephone Adaptor
(ATA) so you can use the Owtalk service. But first you must be an Owtalk
subscriber.
Linksys ATA can be available in preconfigured mode, labeled as Owtalk
Preconfigured on the surface of the packaging box. Under the preconfigured
mode, all Owtalk SIP account information are pre-programmed, you don't
need to go through the following procedures. Please refer to Appendix A on
how to activate an Owtalk preconfigured device.
Steps to self-configure
Linksys ATA
Sign up for Owtalk at
1
configuration information for Linksys ATA.
Plug the power cord and connect the WAN port on the back of the ATA
2
to your cable/ADSL modem, router, or broadband Internet connection.
The factory default network setting of most of the ATA is set as DHCP
3
mode, i.e. the device obtains the IP address automatically from the net-
work. Follow the steps below if your ATA is in DHCP mode. Otherwise
please refer to the device user manual on how to configure your device
to connect to a LAN or Internet under Static IP or PPPoE mode.
To obtain the IP address of the Analog Telephone Adaptor PAP2, press
4
110# on your traditional landline phone after connected to the adaptor
to get your IP address.
http://www.owtalk.com to get your self-