The Qos Policer Setup Screen - ZyXEL Communications VMG8924-B10A Series User Manual

Table 50 Class Setup: Add/Edit (continued)
LABEL
Apply
Cancel

10.6 The QoS Policer Setup Screen

Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Setting > QoS > Policer Setup. The screen appears as shown.
Figure 75 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 51 Network Setting > QoS > Policer Setup
LABEL
Add new Policer Click this to create a new entry.
#
Status
Name
Regulated
Classes
Meter Type
Rule
Action
Modify
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic of the
member QoS classes.
This shows the how the policer has the VMG treat different types of traffic belonging to the
policer's member QoS classes.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by
one when you take this action.
VMG8924-B10A and VMG8924-B30A Series User's Guide
169