Message Lists - Sony VPL-HW40ES Operating Instructions Manual

Message Lists

Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please replace the Lamp/
Filter.
Please clean the filter.
Please clean the filter. Have
you finished? Yes No
Projector temperature is
high. Cooling Setting
should be "High" if
projector is being used at
high altitude.
Power Saving Mode is set.
Projector lamp will
automatically cutoff in 1
minute.
Power Saving Mode is set.
Projector will
automatically enter
Standby Mode in 1 minute.
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (1 page 64)
c It is time to replace the lamp. Replace the lamp. (1 page 57)
c Also, replace the air filter too. Restart cleaning the ventilation
holes (intake). (1 page 57)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 57)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 60)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 60)
c If you cleaned the air filter, select "Yes." If you did not clean the
air filter, select "No."
c Check to ensure that the ventilation holes on the unit are not
covered. (1 page 4)
c When using the projector at high altitude, set the Cooling
Setting to "High". (1 page 39)
Note
When temperature inside the projector remains high, the Cooling
Setting is switched to "High" in 1 minute, then the fan speed
increases.
c "Power Saving" is set to "Lamp Cutoff." (1 page 40)
Note
If no signal is input, the lamp turns off after 1 minute.
c "Power Saving" is set to "Standby." (1 page 40)
Note
If no signal is input, the power turns off after 1 minute, and the
projector goes into standby mode.
55