Panaboard Operation Panel - Panasonic UB-5315 Operating Instructions Manual

Computer Interfacing

■ Panaboard Operation Panel

It is possible to perform the same operations as with the electronic board control panel (page 9) from the following
Panaboard Operation buttons.
Note
• While the Panaboard Operation Panel is displayed, the Copy Key and 2-Screen Copy Key on the electronic
board control panel are used for scanning images into the computer.
Panel
Contrast/
Remaining Film
Indicator
Contrast Button
2-Screen Scan
Button
Multi-Copy/
Error Indicator
Multi-Copy/Stop
Button
Scan Button
Advance Button
28
Name
This lamp indicator notifies the user when the time to
replace the thermal transfer film is approaching (estimated)
and of the contrast used during scanning or copying.
Indicator off:
Indicator on:
Indicator flashing*: Almost time to replace the thermal
*The flashing indicator will go out after the power is turned off, or
the printer has been opened and closed. (When copying is per-
formed, this indicator will begin flashing again.)
Each time this button is pressed, the unit will alternate
between normal and dark contrast modes (Normal/Dark).
This button scans the front and back of the screen on a
single page.
This indicator displays the number of copies to be made.
The display changes each time the Multi-Copy/Stop Button
is pressed.
Example: 1 → 2 → ··· → 9 → 1 → ···
When an error occurs, a flashing symbol will appear in this display to
indicate the error status. (See page 33.)
When making multiple copies, press this button until the
desired number of copies is displayed on the Multi-Copy/
Error Indicator. This button can also be pressed to stop
copying while executing multiple copies.
• The display changes as shown below each time the screen is copied.
After reaching 0, the display will reset to 1.
Example: 5 → 4 → 3 → 2 → 1 → 0 → 1
* If scanning, the setting 1 to 9 for the number of copies is
ignored.
This button scans the screen.
Clicking this button advances the screen from right to left.
Description
Normal scanning or copying contrast
Darker than normal scanning or
copying contrast
transfer film
(Note that only about 15 more sheets may
be copied when this indicator starts
flashing.)
Replacement film (UG-6001) is separately
available from the dealer where you purchased
your unit.
(Number is counted down.)