Table of Contents
Advertisement
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
!
www.mymowerparts.com
Fit the rubber sheath back in place and connect the
hoses to the motor. Do not forget the jubilee clamp on
the return hose.
Bolt the bar plate onto the ball joint mounting, fit the
motor to the bar plate and screw on the chain drive cog.
Place the bar as far back as it will go on the bar plate. Fit
the gasket, chain tensioner, and bar bolts, tighten with
your fingers.
WARNING! Always wear gloves when handling the
chain.
Place the chain around the drive cog and the bar, ma-
king sure it sits correctly in the groove in the bar. The
cutting edge on the chain links must face forward on top
of the bar. Tighten the bolts.
Hydraulic motor
The hydraulic motor is equipped with a small pressure
relief valve. This opens if there is a blockage in the return
hose. If it opens without cause it must be replaced. Use
tool 502 42 50-01.
NOTE! The pressure relief valve may leak when the
hydraulic oil is cold.
9
45
Hide quick links:
Advertisement
Table of Contents
