Samsung 1404262L User Manual page 26

tzozAb e ,,shootng
_!_:_!_i_i_i_i_i_i_i_i_i_i_i_i_i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i_iiiii_ii!!ii_i_i_i!
The water supplied is soft and too
Leaves glasses with much detergent was used.
a light film: Aluminum dishes were included in
the wash load.
Leaves a yellow This is caused by coffee and tea
or brown film On soils.
the inside of the
dishwasher.
There is no rinse aid in the
dispenser.
The temperature of the water
is low when the dishwasher is
running.
Does not dry dishes Too many dishes have been
loaded.
Glasses and cups with concave
bottoms hold water. This water
may spill onto other items when
unloading.
Water was left over from an
incomplete cycle.
Underload the dishwasher and use a rinse
aid to minimize this.
Remove the marks on the dishes using a
low sensitivity cleaner.
Remove the soils using a spot cleaner.
Check the dispenser and add rinse aid.
Use a liquid type rinse aid.
Connect the water supply line to a hot
water supply.
Use rinse aid with the Sanitize option.
Proper loading of items can affect drying.
Load your dishes as recommended.
(See page 16.)
After finishing the cycle, empty the lower
rack first and then the upper rack. This will
)revent water dripping from the upper rack
onto the dishes in the lower rack.
Insert detergent without loading dishes,
and run the Normal cycle to clean the
dishwasher.
The Drain Hose is obstructed. Contact a qualified service technician to
Has a bad odor. remove any obstruction from the drain
hose.
The dishwasher is not used daily With the dishwasher empty and no
or soiled dishes are left in unit too detergent, place a glass with 8 ounces of
long. vinegar upright into the lower rack, and
then run a Normal cycle.
Sound is generated when the This is normal operation.
dispenser cover is open and the
drain pump is operating in an early
stage.
The dishwasher is not level. Ensure the dishwasher is level.
Foreign material (a screw, a plastic Contact a qualified service technician to
piece) is in the pump chamber, remove foreign material from the pump
chamber.
.................. There is a 'chopping' sound Rearrange the dishes.
because a nozzle is bumping
against the dishes.
The nozzle hole is clogged with Clean the nozzle hole.
Does not have a food particles. See pages 22 and 23.
smoothly rotating The nozzle is blocked by a dish or After placing the dishes into the racks,
)ot and cannot rotate, rotate the nozzles by hand to check
whether any of the dishes interfere with
them.
English - 26