Fujitsu Docomo F-07F Instruction Manual page 110

<cid> : Enter any number between 2, 5-10.
<PDP_TYPE> : IP or PPP
<APN> : Dialup connection (APN)
+CGDCONT command
command"
If nothing is displayed even when AT command is
entered, enter ATE1 and press
3
End the terminal software.
Setting Show/Hide caller ID
You can set to show/hide call ID for packet communication at once.
Caller ID is your important information. Take care when deciding to disclose your caller ID.
If "Not notify" is set when using mopera U, connection is unavailable.
1
Activate the terminal software to enable AT command input.
2
Enter notify/not notify of caller ID in the format "AT
<n> : 0-2
0 : Connect directly (Default)
1 : Connect prefixing 184 (Not notify)
2 : Connect prefixing 186 (Notify)
If nothing is displayed even when AT command is
entered, enter ATE1 and press
3
End the terminal software.
❖
Show/Hide caller ID function by dialup network settings
The dialup network settings can also be used to append 186 (Notify)/184 (Not notify) to the dialup
connection number.
The Show/Hide of caller ID when both of the
as shown below.
Setting made by
Dialup network
setting (<cid>=2)
99 2#
184 99 2#
186 99 2#
P32 "Supplement to AT
.
.
DGPIR command and dialup network settings are set is
DGPIR
command No setting
Caller ID is sent
16
DGPIR=<n>"
Caller ID is not sent Caller ID is sent
Caller ID is not sent
Caller ID is not sent
Caller ID is sent
.
Caller ID is sent