Electrical Connection - Zanussi ZFT11112WE User Manual

CAUTION!
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket. In case you do not want to
carry out the above mentioned
operations, contact the nearest After
Sales Service Force. The After Sales
Service specialist will carry out the
reversibility of the doors at your cost.

Electrical Connection

CAUTION!
Any electrical work required to install
this appliance should be carried out
by a qualified electrician or
competent person.
WARNING!
This appliance must be earthed. The
manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
12
A
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either with the
letter "E" or by the earth symbol
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or
coloured red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure
over the outer sheath.
Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse
(B). In the event of having to change the fuse in
the plug supplied, a 13 amp ASTA approved
(BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp
socket is a serious safety (shock)
hazard. Ensure that it is disposed of
safely.
B
C
D
E
or
www.zanussi.com