NETGEAR FWG114P Reference Manual page 100

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
The Router Status screen shows the following parameters:
Table 8-1. Status Fields
Field
System Name
Firmware Version
Printer Status
WAN Port
MAC Address
IP Address
DHCP
IP Subnet Mask
Domain Name Server
LAN Port
MAC Address
IP Address
DHCP
IP Subnet Mask
Wireless Port
Name (SSID)
Region
Channel/Frequency
Mode
Wireless AP
8-2
Description
The System Name assigned to the router.
The router firmware version.
The printer status.
These parameters apply to the Internet (WAN) port of the router.
This field displays the MAC address being used by the Internet (WAN)
port of the router.
This field displays the IP address being used by the Internet (WAN) port
of the router. If no address is shown, the router cannot connect to the
Internet.
This field if the WAN port DHCP settings are dynamic or static.
This field displays the IP Subnet Mask being used by the Internet (WAN)
port of the router.
Identifies the IP address of the DNS server(s).
The Media Access Control address being used by the LAN port of the
router.
The IP address being used by the Local (LAN) port of the router. The
default is 192.168.0.1
Identifies if the router's built-in DHCP server is active for the LAN
attached devices.
The IP Subnet Mask being used by the Local (LAN) port of the router.
The default is 255.255.255.0
This field displays the wireless network name (SSID) being used by the
wireless port of the router. The default is Wireless.
This field displays the MAC address being used by the wireless port of
the router.
Identifies if the channel the wireless port is using. See
Channels" on page D-7 for the frequencies used on each channel.
Identifies if the channel the wireless port is set for 802.11b, 802.11g or
both.
Identifies if the wireless access point is on or off.
December 2003, M-10177-01
"Wireless
Maintenance