Hob with frame or bevelled edge
Installation
The exact positions of the spring
clamps and the safety brackets (only
for hobs with bevelled edge) are
shown in the building-in dimensions
for the particular hob.
Hobs with bevelled edge:
The sealing strip will ensure that the
hob sits securely in the cut-out. Any
gap between the frame and worktop
will reduce with time.
^ Make the worktop cut-out according
to the dimensions given in the
building-in dimensions. Remember to
maintain the minimum safety
disances (see "Safety instructions for
installation").
16
Worktops made of wood
^ Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
Make sure that the sealant does not
come into contact with the top of the
worktop.
^ Place the spring clamps and the
safety brackets (only for hobs with
bevelled edge) (supplied) on the
upper edge on or at the upper edge
of the cut-out.
^ Secure the spring clamps a and
safety brackets b using the
3.5 x 25 mm wood screws supplied.