Status Monitor - Hitachi CP-X9110 User Manual

Status Monitor

Status Monitor
The Status Monitor is the sub LCD in the side panel
that displays the information in the following.
• Current status of the projector. (
23)
• Error log. (

24)
• Lamp log. (

25)
• Filter log. (

• Network information. (
You can execute the following operation in the Status
Monitor.
• Lamp Time reset (
Displaying the condition of the projector
If no buttons are pressed, the Status Monitor displays the current status (Normal,
Warning or Error) as below.
•Normal (example) (
C O M P U T E R I N 1
1 6 0 0 x 1 2 0 0 1 0 0
@
A C 2 4 0 V 3 5 ° C
NOTE
• The Status Monitor displays nothing while the projector is in standby
mode if the STANDBY MODE item of SETUP menu is set to SAVING (
• When INSTALLATION in the SETUP menu is set to FRONT / CEILING or REAR /
CEILING, the contents on the Status Monitor are displayed upside down (
20
23)

25)

24)

22
) •Warning (example) (

23
)

A I R
Status Monitor
•Error (example) (
L A M P
70
).
70
23
)

).