Troubleshooting - Canon Image stabilizer 10x30lS Instructions Manual

Troubleshooting
If there is a problem with the binoculars please refer to the following
table.Ifthe problem persists, contact your nearest Canon Service Center.
Problem Probable Cause Corrective Measure
The image is not clear. The lens is dirty. Use a blower brush to
remove dust, etc., from the
lens surface. Then use a
dry, soft cloth to wipe the
lens gently.
The width between the Adjust the width between
eyepiece lenses has not the eyepiece lenses. (See
been adjusted properly.
step 4.)
The diopter setting has not Adjust the diopter setting.
been properly adjusted. (See step 5.)
The image is not properly Focus the image. (See step
focused. 6.)
The image stabilizer does Batteries have not been Install batteries and make
not operate.
installed.
sure they have enough
power.
When the image stabilizer The lamp will not light if
switch is pressed, the lamp the battery power is low.
does not light. Replace the batteries with
new ones.
The battery power is low. Even if the lamp lights,
the battery power may be
too low for the image
stabilizer to operate.
Replace the batteries with
new ones.
When the binoculars are The batteries are
shaken roughly while the exhausted. Replace the batteries with
image stabilizer is new ones.
operating, there is an
abnormal noise.
There is an air bubble in Air bubbles may form in
the lens. the lens when the The air bubbles will
atmospheric pressure is disappear after about a
low, such as in airborne week, depending on the
airplanes and on high atmospheric pressure and
mountains. This is not an usage conditions.
abnormality.
18