Changing The Low Setting Jets - Miele KM 360 Installation Instructions Manual

Changing the low setting jets

(all burners)
To change the low setting jets the
fastening screws of the burners must
be loosend and the upper part of the
appliance has to be taken off.
^ Pull off the control knobs.
^ Take off the upper part.
Stainless steel:
Lift at the rear, slide forward and take
off.
Ceramic:
Insert the supplied tool at the corner
between the appliance frame and
worktop, lift the top and take it off.
Conversion to another type of gas
a
b
^ Take off the ignition switch a.
^ Loosen the low setting jet b with a
small screw driver.
^ Pull out the jet with a pair of pointed
pliers.
^ Install the new jet according to the jet
table and tighten.
23