Pppoe (Dsl) - D-Link DIR-640L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password.
This option is typically used for DSL services. Please be sure to remove your PPPoE software from your computer.
My Internet
Connection Is: Select PPPoE (Username/Password) from the drop-down menu.
Auto-Backup: Check this box to enable wired-WAN alive if you have 3G failover.
Internet host: Enter the IP address for the auto-backup host.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in the next box.
Service Name:
Enter the ISP service name (optional).
Reconnect
Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Time:
auto-reconnect.
DNS Addresses:
Enter the primary and secondary DNS server addresses (Static PPPoE only).
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default
MTU.
MAC Address: The default MAC address is set to the Internet port's physical interface MAC address on the broadband router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Copy Your PC's MAC Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-640L User Manual

PPPoE (DSL)

23