Items Relating To Remote Interface (Nos. 201 To - Sony SRW-5000 Operation Manual

Item number Item
129 STOP CODE
FUNCTION
Sub items
DETECT BEEP
DETECT STOP
STOP ADJUST
REC ADJUST
130 S-LCD DIMMER
131 CHANGED MENU
HIGHLIGHT
Sub items
ITEM SETTING
DEFAULT
SETTING
132 KNOB MODE

Items Relating to Remote Interface (Nos. 201 to ...)

Item number Item
201 REMOTE 9-PIN
202 REMOTE 50-PIN
Setting Function
Stop code detection mode and adjustment of stop position
when a stop code is detected.
on on: When a stop code is detected, sound a beeper.
[off] off: When a stop code is detected, do not sound a beeper.
on on: When a stop code is detected, stop the tape. ("D-
[off]
off: When a stop code is detected, do not stop the tape.
150 fr When a stop code is detected, adjust the tape stop position
[0 fr]
from the normal stop position in the direction of the SOM
point (program start point), in the range 0 to 150 frames.
5sec Specifies how many seconds before the SOM point to start
4sec recording a stop code.
[3sec]
2sec
1sec
16 to [11] to 0 Adjusts the information display luminance.
Changes the display color of items whose setting has been
changed.
[off]
off: Changed menu setting values do not change display
on
on: Changed menu setting values are displayed in yellow.
[off] off: Menu numbers with changed DEFAULT values do not
on
on: Menu numbers with changed DEFAULT values are
[set default] Selects the behavior of the unit when the MULTI CONTROL
move window knob is pressed during VTR SETUP menu operations.
set default: When a setting value is being selected, selects
move window: Move between the item window and the
Setting Function
[off] When this is set to "on", this unit is controlled from the
on device connected to the REMOTE 1-IN(9P) or REMOTE 1-
I/O(9P) connectors.
Note
When this unit is controlled by a device connected to the
REMOTE 1-IN(9P) or REMOTE 2 PARALLEL I/O(50P)
connector, the editing control buttons and all of the tape
transport buttons except STOP and EJECT are disabled. It
is also possible to make a setting so that all of the buttons
are disabled.
For details, see item 008.
[off]
When this is set to "on", this unit is controlled from the
on device connected to the REMOTE 2 PARALLEL I/O(50P)
connector.
STOP" appears in the information display.)
color.
change display color.
displayed in yellow.
the default value.
window for changing values.
147
Menu List