Cable Connection; Start-Up Conditions At The Programmable Controller - AEG P610 Operating Instructions Manual

3.5.1

Cable Connection

The RS 232 C port (COM1) on the P610 should be used for connection to the
programmable controllers (see also Figure 8). The required cables are specified
in the tables below (Table 1 and Table 2).
Table 1 Cable Connection from the P610 to the Programmable Controllers
A010 A020 A030 A120
(plus)
YDL 057 YDL 057 YDL 057 YDL 052
Table 2 Cable Connection from the P610 to the Programmable Controllers (Continu-
ation)
A500 (ALU) 984-X8X 984-A/-B/-X
25-pole 9-pole
YDL 057 YDL 052 W956-012 W958-001 +
or W907-015
W956-025 or
W907-025
3.5.2

Start-up Conditions at the Programmable Controller

The baud rate of the P610 is automatically adjusted. The baud rate may not ex-
ceed a value of 9600 baud.
Further start-up conditions at the programmable controller can be found in the
corresponding user manuals for the programmable controllers.
22
A130 A250 A350
YDL 057 YDL 052 YDL 057
Programming Requirements 17