Table of Contents
Advertisement
14. Place the fan and heat sink into position on the microprocessor.
15. When tightening the screws that clamp the heat sink, do not overtighten.
16. Reconnect the fan to the system board connector.
17. If you are replacing a failing system board, go back to the system board
Removing and replacing drives
Microprocessor
Tighten the clamp screws evenly by tightening one side some and then the
other until they are both snug.
procedure. Otherwise, go to "Closing the cover and connecting cables" on
page 104.
1. Remove the cover. See "Removing the cover" on page 92.
2. If you are removing the hard disk drive or diskette drive, remove the front
bezel by releasing the four plastic tabs inside the chassis and pressing down
on the top of the bezel.
0.01 mL of
thermal grease
Chapter 8. Replacing FRUs (Types 8126, 8174, 8175, and 8176)
101
Hide quick links:
Advertisement
Table of Contents
