Chapter2 Installation Of The Scanner; Installing The Scanner - Fujitsu fi-6140 Getting Started

Chapter2

2.1 Installing the Scanner

1. Place the scanner at its installation site.
For details on the scanner's dimensions and required
installation space, refer to chapter 9 "SCANNER
SPECIFICATION" of "fi-6140/fi-6240/fi-6130/
fi-6230 Operator's Guide" in the Setup CD-ROM.
For fi-6140/fi-6130, go to Step 3.
2. Unlock the Transport lock.
The carrier unit inside the fi-6240/fi-6230 is fixed in
place with the transport lock to prevent the scanner
from being damaged during transportation.
To unlock the transport lock, slide the transport lock
switch on the scanner front.
Lock
3. Attach the ADF paper chute.
Hold the ADF paper chute and insert its tabs into the
corresponding slots in the scanner as shown in the next
figure below. Let the ADF paper chute down to fit into
position.
The Side guides of the ADF paper chute have to face
up.
ADF paper chute
fi-6140/fi-6240/fi-6130/fi-6230 Image Scanner Getting Started
INSTALLATION OF THE SCANNER
Release
2
1
Side guide
Tab
4. Connect the AC adapter.
Use only the supplied AC adapter.
1) Connect the AC cable to the AC adapter.
2) Connect the AC adapter connector to the scanner's DC
inlet.
3) Plug the AC cable into an outlet.
The Function Number Display and LED of the operator panel
on the scanner may flash for an instant when the AC cable is
plugged into an outlet. This is a phenomenon due to the
initial diagnosis, but not a failure.
3