Settings Data/Backing Up Or Restoring Logs [Data] - Panasonic WV-SFV311 Operating Instructions Manual

[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
Note
•
To initialize the network settings (®page 139), turn off the power of the camera, then turn on the power
again while holding down the INITIAL SET button on the unit, and keep the INITIAL SET button held
down for about 5 seconds. Wait about 3 minutes after releasing the button. The camera will start up
and the settings including the network settings will be initialized. Do not turn off the power of the unit
about 3 minutes after turning on the power.
•
The notification function allows users to provide the notification of the error to the specified destination
E-mail address and an original alarm destination when an error such as no SD memory card insertion
after the reboot or a locked SD memory card insertion occurs. (®page 144, page 126)
18.5 Settings data/backing up or restoring logs
[Data]
Click the [Data] tab of the "Maintenance" page. (®page 40, page 42)
Backup/restore of the setting data of this unit and saving of the log is performed.
Backup
•
[Setup data]
Click the [Execute] button to backup the setup data of the camera to a PC.
•
[Scene file]
Click the [Execute] button to backup the scene files of the camera to a PC.
•
[Logs]
Click the [Execute] button to backup the log data of the camera to a PC.
18 Maintenance of the camera [Maintenance]
Operating Instructions 187