Table of Contents
Advertisement
towards the face mask (4), while at the
same time pushing upwards (5).
(Alignment of the second tab is made
easier by applying pressure to the point
(3) shown below.)
Figure 2.
Face Shield
Assembly
3. Install the
dark glass
(D) by
sliding it
into place
behind the
glass
retaining tabs (E).
4. Once protective dark glass has been
installed into face shield, secure it in
place with the retaining clips (F). Align the
holes on each of the retaining clips with
the pins on the retaining tabs and firmly
press into place.
INSTALLING THE HANDLE
1. Line up the holes in the handles with the
holes on the top of the welder.
2. Place a lock washer then a washer onto
the welder handle screws.
3. Insert the screws with the washers
through the holes on the welder handle
and into the top of the welder and tighten.
(see Figure 3)
Figure 3. Handle Installation
ALIGN AND SET THE DRIVE ROLLER
Before installing any welding wire into the
unit, the proper sized groove must be placed
into position on the wire drive mechanism.
Figure 4. Feed Motor
Adjust the drive roller according to the
following steps:
1. Open the door to the welder drive com-
partment.
2. Remove the drive tension by loosening
the tension adjusting knob and lifting the
Drive Tension Adjustor away from the
Drive Tension Arm. Pull the drive tension
arm away from the drive roller.
3. If there is wire already installed in the
welder, roll it back onto the wire spool by
hand-turning the spool counterclockwise.
Be careful not to allow the wire to come
out of the rear end of the inlet guide tube
without holding onto it or it will unspool
itself. Put the end of the wire into the hole
on the outside edge of the wire spool and
bend it over to hold the wire in place.
Remove the spool of wire from the drive
compartment of the welder.
4. Rotate the Drive Roller Cap counterclock-
wise and remove it from the Drive Roller.
5. Pull the Drive Roller off of the Drive
Roller Shaft.
Figure 5. Drive Roller Adjustments
11
Advertisement
Table of Contents
