Panasonic AG-7350 Series Service Manual page 58

5. Press the sub wiper arm (R) to direction indicated by
arrow so that the sub wiper arm (R) comes to cassette
down position (STOP) completelyas shown in Figure
M62 and keepit.
In this position, the arrow on the Sub Wiper Arm (R)
should align with the arrow on the Rack (A)(1) Unit as
shown In Figure M63.
Sub Wiper Arm (R)
Figure M62
<Right Side View>
Sub Wiper Arm (R)
Figure M63
6. If the Cassette Compartment is not aligned, re-align-
ment may be accomplished by pushing the Main Shaft
Unit to the right (gently) and pushing the front of the
Rack Unit to the left. This procedure will disengage the
teeth of the Rack Gear from the teeth on Sub Wiper Arm
assembly. This will allow you to change the positional
relationship between the Sub Wiper Arm Assembly and
Rack Unit. This procedure is best attempted in the
EJECT position. Once this is done, check for smooth
operation of the compartment by inserting a cassette,
and pushing in, and down.
4-20
C. Installation Procedure
1 . Bring loading mechanism to the STOP (Sub-load) posi-
tion.
2. Confirm that the chassis is aligned properly for Align-
ment Condition as shown In Figure M46 and M47.
3. Put the Sub Wiper Arm (R) In its full down position (Sub
Wiper Arm should rest on plastic protrusion on the
bottom of the right side plate).
4. Install the cassette compartment (without cassette
holder) to chassis so that the rectangular marking (or
slot) on the connection gear should be line up with first
tooth of the Rack Gear as shown In Figure M64 and
M65.
6 O'clock position
Marking
First Tooth
Marking Position is in line with
First Footh of Rack Gear A (1)
Figure M64
0
.....-----Rack Gear A (1)
®
Marking (Solt)
Figure M65