Bosch RF835E Series Installation Manual

RF835E Series Wireless
TriTech PIR/Microwave
Intrusion Detector with
Pet Immunity
en Installation Guide
Notice:
Product must be installed in accordance with
NFPA70, Local Authorities Having Jurisdiction
(AHJ's) and all local codes.
Batteries must not be disposed of in household
waste. Dispose batteries at suitable collection
points. For further information refer to
http://boschsecurity.com/standards.
Optional Bracket:
B328, B335, B338, B800
Specifi cations
General
• Dimensions (HxWxD): 13.9 cm x 7.2 cm x 6.9 cm (5.4 in x 2.8 in x 2.7 in)
• Power supplied by four 1.5V AA Alkaline Batteries. Recommended Batteries:
Panasonic AM-3,Duracell MN1500, or PC1500 Energizer E91.
• Typical current draw is 100 μA with the LED disabled. The LED is automatically
disabled except during walk tests.
• Typical battery life is two to three years.
• Operating temperature range of 0°C to +49°C (+32°F to +120°F).
• Relative humidity range of 0% to 95% (non-condensing).
• Microwave Frequency: RF835E is 10.525 GHz, RF835E-C is 10.588 GHz
• RF Transmit Frequency: 433.0 MHz.
1 Installation. Gently insert a fl at-
bladed screwdriver into notch for
the section you wish to remove, and
then lift on the section to unhinge.
NOTICE:
Do not twist.
© 2012 Bosch Security Systems, Inc.
2.0 m - 2.4 m
(6.5 ft - 8 ft)
Recommended:
2,2 m (7.5 ft)
Receiver
1
Receiver Range: 150 m (500 ft)
Recommended: 30 m (100 ft)
TriTech Motion Sensor
• Coverage area 10.7 m by 10.7 m (35 ft by 35 ft).
• Internal coverage pointability -4° to -10° Vertical.
• Field selectable sensitivity options of Standard and
the more sensitive setting of Intermediate.
• Three minute transmitter lockout time after alarm
extends battery life.
• Timed Walk Test Mode automatically disables LED
after setup to extend battery life.
• Cover activated Tamper indication. Optional wall-acti-
vated Tamper is included.
2
Height and Adjustment
Loosen the Vertical Adjust Screw. Adjust the board to the desired angle.
Choose mounting height and desired range and set the vertical angle.
Mounting Range
Height
6.1 m (20 ft)
2 m (6.5 ft) - 7 °
7.0 ft (2.1 m) - 9 °
- 10 °
8.0 ft (2.4 m)
NOTICE:
The mounting height must be 2 m (6.5 ft) and the vertical
angle must be set at -5° for installations containing pets.
6.5 ft.
(2 m)
Mount the detector Do not point where
2 m (6.5 ft) above the fl oor. pets can climb.
PIR Sensitivity Selection Pins
10.7 m (35 ft)
- 5 °
- 6 ° INT
STD
- 7 °
INT
STD
1 dog ≤ 45 kg (100 lb),
2 dogs ≤ 27 kg (60 lb),
The upper areas are
not pet immune.
RF Transmitter
• Integral RF transmitter capable of transmitting 150
m (500 ft) in open air. (Actual acceptable transmit-
ter range should be verifi ed for each installation). In
normal operation, it is recommended that the RF835 be
within 30 m (100 ft) of the receiver.
• Transmits low battery reports and tamper reports to the
control panel.
• Transmits supervisory signal to the control panel every
13 minutes.
Set the PIR Senstivity Vertical adjusing
3
screw must be securely tightened after
setting the angle.
Vertical
Adjust
Screw
- 6
INT
For pet immune
STD - 10
applications, adjust
- 6
- 10
the angle to -5.0.
MAX
MIN
MW
F01U254570 | 03 | 2012.11 | 1
Pet Friendly
or up to 10 cats