Sony EVI-D100 Operating Instructions Manual page 44

Note
Repeat the above-mentioned procedure for
each Remote Commander if you are using
more than one Remote Commander. This is
because the setting is performed by
changing the signal emitted from each
Remote Commander, not by changing the
setting of the camera itself.
If the STANDBY lamp flashes
The micro computer inside the camera
might not memorize the current pan/tilt
position properly. Press the PAN-TILT
RESET button to reset the pan/tilt position.
Operating range of the Remote
Commander
Use the Remote Commander within the
illustrated range, facing it toward the sensor
for the Remote Commander. The POWER
lamp flashes while the main unit receives a
signal from the Remote Commander.
Sensor for the Remote Commander
30 degrees
60 degrees
60 degrees
20 degrees
44
Pan/Tilt Operation
Flashes
7m
Operating more than one camera
with the Remote Commander
1
Set the IR SELECT switch (at the rear
of the main unit) of the camera(s)
which you intend to operate to 1, 2 or
3.
2
Press a CAMERA SELECT button
(on the Remote Commander) which
corresponds to the number set in step
1.
Then, you can operate the camera(s)
specified by number. Every time you
operate the camera(s) using theRemote
Commander, the CAMERA SELECT
button pressed in step 2 lights up.
IR SELECT
1 2 3