Beko P7 Service Manual page 64

2-5. The screen display has a problem for
Scan FPC.
(1) It's may be a problem between Scan FPC and Y B/D.
(2) Check the connection of Y B/D and Scan FPC.
(3) If the Scan IC is failed, replace the Y DRV B/D.
[ [ Screen Display Form
The screen display is very good
The screen display is poor
[ [ Check a method of SCAN IC
Change the Vpp Pin into ANODE and GND Pin into CATHOD
and then test the Diode with forward or reverse direction.
2-6. The screen has a vertical line with
regular gap.
(A vertical stripe flash at especial color)
(1) This is a problem about control B/D.
(2) Replace Control B/D.
[ [ Screen Display Form
one eighth
of screen
The screen has a vertical line
2-7. A data copy is happened into vertical
direction
(1) In this case, it's due to incorrect marking of scan wave.
(2) Replace a Y DRV B/D or Y SUS B/D.
[ [ Screen Display Form
<Display Pattern>
<Case 2 : Top Copy> <Case 3 : Bottom Copy> <Case 4 : Entire Copy>
- 14 -
with regular gap
<Case 1 : Entire Copy>