Page 1
ANGLOPACK Quick Setup Guide Hitachi H4021 modem Required configuration - A standard line: non-shared analog (excluding “Numeris” and switchboard) - A subscription to the ADSL service AngloPack from Teleconnect - A standard telephone (optional) - A computer with the following characteristics: •...
Installation 1/ Configure your computer network 2/ Connect your equipment As described on the 'Connexion Map' page • The Internet Protocol properties should be set to: • Due to auto configuration mode, the modem may self-reboot, so please wait until •...
Page 4
Connection map Do not insert any ADSL filter YOUR COMPUTER between the cable and the socket Default: yellow Main RJ45 male cable telephone Green RJ11 male cable (Ethernet) socket Note: - USB connexion is done using blue cable - No cable needed if you use Wi-Fi Cable and power supply block...
Wi-Fi configuration (optional) For more convenience the Wi-Fi interface of 2/ Enable/Disable Wireless your modem is enabled. But you can choose to The following screen displays. Tick the 'Enable Wireless' check • box as wanted, then Save/Apply. enable/disable it as wanted. See below. 1/ Access the modem configuration interface In order to do so, open Internet Explorer •...
What to do in the event of a problem? Event Test procedure or possible cause Check that the power supply block is properly plugged in. The POWER LED is not lit Check that the power supply cable is properly connected to your terminal. Check that the electrical socket is working correctly and that your electrical supply is on (power cut…).