Mounting The Accessories For Manual Control System - Canon XJ100x9.3B AF Operation Manual

1 HOW TO MOUNT
1-4 Mounting the
Accessories for Manual
Control System
Mount and connect the flexible zoom and focus control units
as shown in the figure.
When mounting the various demands, refer to the operation
manual for the respective demand.
Flexible module
Flexible zoom control unit
Flexible focus control unit
Flexible cable
Switch box unit
Mounting the flexible module
It is necessary to mount the flexible module to the zoom and
focus couplings located in the bottom compartment of the
lens.
* (NOTE)
The same flexible module is used for both zoom and focus
couplings. So, it can be mounted on either the zoom or focus
coupling.
1
Before mounting the module to the lens, turn the lock
screw of the module counterclockwise until the lock
axis comes out to its a half way of length.
2
Press the module in the direction of arrow "A", so
that the key pins on the lens are inserted in the key
grooves of the module.
3
Mate the coupling A of the module with the coupling
B of the lens. And then, fully push the module in the
direction of arrow "B" until it stops.
4
Finally, turn the lock screw of the module clockwise to
secure it. By using a coin, tighten firmly the lock knob.
Next, as the same procedure, install the flexible module
on the other joint. It does not matter which is installed first,
either the zoom or the focus.
Bottom compartment of the lens
Key Pin
Coupling B
Key Groove
Coupling A
E6
Lock Axis
Lock Screw
Lock