Replacing Drawer Glide Rails
The lower oven drawer glide rails (Fig. 8) clip into
Fig. 8
the side wall of the lower oven cavity and are se-
cured by one screw in each rail.
The mounting screw is accessed through a hole in
Fig. 9
the glide rail outer track. (Fig. 9) .
Remove
Screw
Once the mounting screw is removed extend the outer track of the glide rail until it stops. Pull forward
firmly until the hooks on the back of the rail disengage from the slots in the oven cavity side wall.
( Fig. 10 & 11 )
Fig. 10
Fig. 11
Slots
Pull Forward
Glide Rail Hooks
Replacing Drawer seal
The rubber drawer seal is secured to the drawer liner by metal
spring clips that are integral to the seal. To remove the seal grasp
Spring Clip
securely at the clip and pull away from the liner. Replace by
positioning the point of the clip into the hole and pressing in until
the clip locks into place.
Page 44