Removing The Cd Tray; Reinstall The Cd Tray - JVC MX-GT700 Service Manual

MX-GT700
<CD changer unit>
Prior to performing the following procedure, remove
the CD changer unit.
Removing the CD tray (See Fig.1 to 3)
1. Turn the black loading pulley gear on the under side
of the CD changer unit in the direction of the arrow
and draw the CD tray toward the front until it stops.
2. Disconnect the card wire from connector CW103 on
the CD servo board.
3. Push down the two tray stoppers marked a and pull
out the CD tray.

Reinstall the CD tray

1. Align the gear-cam with the gear-tray as shown fig.4,
then mount the CD tray.
2. When assembling the CD tray, take extreme care not
engage with gear - synchro.
Gear-cam
Gear-convert
Gear-convert Gear-tray
1-10
(See Fig.4 and 5)
Gear-tray
Gear-cam
timing point
Fig.4
CW103
Loading pulley gear
CD tray
CD tray
a
(Tray stopper)
Gear-tray
CD tray
CD changer uint (reverse side)
CD servo board
CD tray
Fig.1
Fig.2
a (Tray stopper)
CW103
(on the CD servo board)
Fig.3
Gear-synchro
Fig.5